Q:Basic knowledge of the slide rail
A : The basic characteristics of SLIDEWAY rails at present there are roller rails and ball rails in the market. The conventional ball rails are realized by the ball and the inner and outer rails. SLIDEWAY rails are ball rails, with the advantages of heavy load, long service life and stable operation. Length range: 200mm to 1500mm, rated load: 15kg / 227kg.. Classification of rail load-bearing classification: light load, medium load, heavy load section classification: two rail / three rail application classification: industrial application / carpentry application / structural component terminology for the electronic rail; outer rail / The middle rail/ inner rail/ ball frame/ ball travel, that is, the drawer can be pulled out from the cabinet, the length 3/4 stroke drawer can only be partially opened, and the pull-out part is about 3/4 of the total length of the slide rail. And the opening length of the full-stroke drawer is equal to the total length of the sliding rail. The open length of the over-stroke drawer is longer than the total length of the slide rail. The two-way stroke drawer is stretched in two directions, and the draw length of the drawer is about 3/4. Side clearance side clearance = (cabinet width-drawer width)/2 Load test for rated load rails is based on a pair of slide rails with a length of 457 mm[18 "] without failure (457 mm[18 "] above the length, the bearing capacity will be reduced) for the case. The static load of each slide rail is at least twice the rated load. Selection elements: the selection of slide rail should consider the main characteristics and practical application needs. Length: the length of the slide rail is subject to the maximum size measured when the rail is fully closed. In general, select the maximum length rail that can be allowed in practical applications. Stroke: 3-4, full stroke, over-stroke drawer width: in general, a wide drawer requires a higher load bearing on the slide rail and a larger transverse stress on the cross-section of the rail. Refer to the drawer width recommended in the installation instructions. Movement Mode: continuous motion, progressive motion. Split mode: can be split, can not be split.